ULTRA MAX WHITE
WHITE PROFESSIONAL GRADE ACRYLIC EXTERIOR LATEX PAINT
Where To Purchase:
- Previously painted or bare aluminum
- Vinyl and wood siding
- Clapboards
- Shakes
- Shingles
- Plywood
- Drywall and plaster
- Concrete, masonry, and brick
- Properly primed steel
- Aged or coated galvanized metal
- Not suitable for flooring or high abrasion surfaces
Not designed to inhibit rust. If applied over a previously rusted surface or to inhibit future rust, a coat of oil-based primer (Shopcoat Primer 299) is recommended.
- Brighter white than conventional oil-based products.
- Non-toxic – soap and water cleanup.
- Effective mildewcide is incorporated to restrict mildew growth once paint is dry.
- Offers exceptional economy and durability in a user-friendly water-based formulation.
- Provides excellent weather protection and decoration.
- Safe around valuable horses and livestock.
Characteristics
Color – White
Finish – Semi-Gloss
Flash Point – > 201°F (PMCC)
Viscosity – 85 KU
Available Packaging – 5-gal pails, 55-gal drums
VOC – Less than 250 grams/liter
Shelf Life
2 years unopened, stored out of direct sunlight at temperatures between 40°F and 90°F.
Settling can occur, product must be shaken vigorously before use. For best results, flip pails upside down while shaking.
DO NOT FREEZE
Coverage
Flat Surfaces: 250 sq. ft. / gal.
Coverage depends on many factors such as porosity and roughness of the substrate and material losses during application. Using less than recommended material will lead to decreased durability. May require two coats for best results – especially on previously unpainted surfaces.
On new wood always check for tannin stain by applying to a test area. If it occurs use an oil-based primer such as Fence & Barn White. Allow 24 hours before top-coating with this product.
Drying Time @ 77°F / RH 50%
Set to touch: 1 hour
Re-coat: 4 hours
Fully dry: 24 hours
Drying times are affected by rain, dew, and temperature. Do not paint if rain is expected within 8 hours.
Recommended Film Thickness
Wet film – per coat: 6.0 to 10.0 mils
Dry film – per coat: 2.0 to 4.0 mils
Application
Product should be thoroughly mixed before use. No thinning needed – if necessary, thin with 4 fl. oz. water per gal. paint.
Application temperature: above 50°F
Method: Brush, roll, or spray
Allow new wood 1 to 3 months to weather to reduce moisture content. Do not paint the underside of fence planks.
Airless spray:
- Rating: 0.5 gallons / minute minimum
- Pressure: 1,800-2,500 psi
- Filter: 30 to 60 mesh
- Tip Size: 0.017″ to 0.025″
Surface Preparation
Surface should be free of all dirt, grease, oil, or other contaminants prior to painting.
In areas where mildew is a problem, always scrub the surface with a commercial mildew remover or bleach solution.
