- Plank fences
- Barns
- Barn stalls
- Barn interiors
- Silos
- Farm buildings
- New and weathered wood
- Concrete, masonry, and brick
- Metal structures
- Gates
- Loading areas and chutes
- Not for use on new or uncoated galvanized steel
- Not suitable for flooring or high abrasion surfaces
- Linseed-oil/alkyd formulation for durability and flexibility.
- Self-priming on new lumber.
- Excellent weather protection.
- Excellent color retention.
- Safe around valuable horses and livestock – lead-free.
- Can be used on interior barn surfaces.
- Oil-based formulation is resistant to rust.
- Cleanup with mineral spirits.
Characteristics
Color – Black
Finish – Semi-Gloss
Flash Point – 105°F (PMCC)
Viscosity – 90 KU
Available Packaging – 5-gal pails, 55-gal drums
VOC – Less than 380 grams/liter
Shelf Life
2 years in unopened cans. To maximize shelf life, store out of direct sunlight. Product will not be affected if stored below 32°F.
Settling can occur, product must be shaken vigorously before use. For best results, flip pails upside down while shaking.
Coverage
3 & 4 board fence: 16 ft. / gal., both sides
1 board fence: 26 ft. / gal., both sides
Barns: 250 sq. ft. / gal.
Coverage depends on many factors such as porosity and roughness of the substrate and material losses during application. Using less material than recommended will see a decrease in durability. May require two coats for best results.
Drying Time @ 77°F / RH 50%
Set to touch: 4-6 hours
Re-coat: 8 hours
Fully dry: 24 hours
Drying times are affected by rain, dew, and temperature. Do not paint if rain is expected within 8 hours.
Recommended Film Thickness
Wet film – per coat: 3.5 to 6.0 mils
Dry film – per coat: 1.5 to 2.5 mils
Application
Product should be thoroughly mixed before use. No thinning needed – if necessary, thin with 4 fl. oz. mineral spirits per gal. paint.
Application temperature: above 40°F
Method: Brush, roll, or spray
Allow new wood 1 to 3 months to weather to reduce moisture content. Do not paint the underside of fence planks.
Airless spray:
- Rating: 0.5 gallons / minute minimum
- Pressure: 1,800-2,500psi
- Filter: 30 to 60 mesh
- Tip Size: 0.017″ to 0.021″
Roller application: use thick nap 7” roller.
Fence Preparation
For greatest durability make sure surface is scraped, sanding, or pressure washed thoroughly by removing any peeling or flaking paint before applying. For metal surfaces, ensure surface is clean.
